cisco 1240 AG config in CLI

Cisco 1240 AG AP configuration is not that complex and work as follow:

go to the config t mode to change the settings:

A-qu-AP1#config t
Enter configuration commands, one per line.  End with CNTL/Z.
A-qu-AP1(config)#interface Dot11Radio1
A-qu-AP1(config-if)#no ssid Starbuck

//the existing ssid stabuck has been deleted

//the current interface Dot11Radio0 and interface Dot11Radio1 are down:

A-qu-AP1#show interface Dot11Radio0
Dot11Radio0 is reset, line protocol is down
Hardware is 802.11G Radio, address is 003a.9aad.a030 (bia 003a.9aad.a030)
MTU 1500 bytes, BW 54000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/1127/0/0 (size/max/drops/flushes); Total output drops: 1
Queueing strategy: fifo
Output queue: 0/30 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
1096 packets input, 102895 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
A-qu-AP1#show interface Dot11Radio1
Dot11Radio1 is reset, line protocol is down
Hardware is 802.11A Radio, address is 003a.9aa5.4b90 (bia 003a.9aa5.4b90)
MTU 1500 bytes, BW 54000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/1127/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/30 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
1 packets input, 113 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
A-qu-AP1#

//config the ssid settings to bring all the interface up

A-qu-AP1#config t
Enter configuration commands, one per line.  End with CNTL/Z.
A-qu-AP1(config)#interface Dot11Radio0
A-qu-AP1(config-if)#ssid STARBUCK
A-qu-AP1(config-if)#no shutdown
A-qu-AP1(config)#encryption mode ciphers aes-ccm tkip

A-qu-AP1(config-if)#dot11 ssid STARBUCK
A-qu-AP1(config-ssid)#authentication open
A-qu-AP1(config-ssid)#guest-mode
A-qu-AP1(config-ssid)#authentication key-management wpa version 2
A-qu-AP1(config-ssid)#wpa-psk ascii password
A-qu-AP1(config-ssid)#

//config another interface to add the ssid informations

A-qu-AP1#config t
Enter configuration commands, one per line.  End with CNTL/Z.
A-qu-AP1(config)#interface Dot11Radio1
A-qu-AP1(config-if)#ssid STARBUCK
A-qu-AP1(config-if)#no shut
A-qu-AP1(config-if)#en
A-qu-AP1#wr
Building configuration...
[OK]

//all the interface are up………..//

A-qu-AP1#show interface Dot11Radio0
Dot11Radio0 is up, line protocol is up
Hardware is 802.11G Radio, address is 003a.9aad.a030 (bia 003a.9aad.a030)
MTU 1500 bytes, BW 54000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/1127/0/0 (size/max/drops/flushes); Total output drops: 10
Queueing strategy: fifo
Output queue: 0/30 (size/max)
5 minute input rate 32000 bits/sec, 34 packets/sec
5 minute output rate 211000 bits/sec, 34 packets/sec
10658 packets input, 1144494 bytes, 0 no buffer
Received 316 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
8841 packets output, 8289395 bytes, 0 underruns
0 output errors, 0 collisions, 9 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
A-qu-AP1#show interface Dot11Radio1
Dot11Radio1 is up, line protocol is up
Hardware is 802.11A Radio, address is 003a.9aa5.4b90 (bia 003a.9aa5.4b90)
MTU 1500 bytes, BW 54000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/1127/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/30 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
3 packets input, 337 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 4 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out

all the settings were done,the stupid users could access to the internet

–EOF–